Rice Lake Datamax-ONeil I-4212e Mark II - Manual - Manual (Page 11)

Chapter 2 - Printer Setup 5
2.1.3 USB Connection
USB connection to PC requires installation of drivers for both the Port and the Windows Driver
itself. All the files necessary for installation are located on the Accessories CD-Rom. Connect the
printer to the host PC via a standard USB Cable and follow the steps below. The following steps
are for a typical Windows XP system, other versions of Windows may vary.
Step A: Windows Port Driver Installation:
1. Turn on the printer and wait until
the “Ready” screen appears. The PC
will then detect the printer and
launch the “Found New Hardware
Wizard”.
2. Select the “No, not this time” radio
button and then click Next.
3. Select the “Install from a list or
specific (Advanced)” radio button
and then click Next.
4. Select the “Search for the best
driver in these locations” radio
button.
5. Check the “Include this location in
the search” checkbox and then click
Browse.
6. Navigate to driver folder on the CD-
ROM, assuming your CD/DVD drive
is labeled D: the path would be as
follows:
My
Computer>D:>assets>windriver
7. Select the folder and then Click
‘OK’. Then Click Next.