Rice Lake AX 3040 - Manual (Page 16)

12 AX3040 Operator Manual
5.0 Service Information
The following sections provide information to keep the Rice Lake AX3040 running at peak performance.
Note
Disconnect power from the system prior to inspection or cleaning.
5.1 Cleaning and Maintenance
After proper installation, maintenance is the most critical factor in the operation and life expectancy of the Rice
Lake AX3040. Maintenance checks are surprisingly simple, but are often overlooked or ignored until problems
arise.
It is recommended that the owner do inspections on a daily and weekly basis, and mechanical inspections should be
done at least every six months. Actual frequency of these inspections is relative to the environmental conditions
and usage of the AX3040.
A variety of cleaning procedures should be used to maintain the longevity of the AX3040.
Load Cell Trays
Use either air or light water pressure to clean accumulated dirt and debris from the trays. If water is used to clean
the trays, use air pressure to dry them.
Connectors
If the connectors show signs of dirt or corrosion, clean them with a small stiff (dry) brush. Clean connector pins
with a commercial non-residue contact cleaner. Do not use oil or a silicon base cleaner. They will leave a residue
that can trap dirt. Also, denatured alcohol in a trigger spray bottle is an excellent cleaner. Drench the connector
with the cleaner. Wait until the connectors have thoroughly dried before reconnecting.
5.2 Maintenance Checklist
Note
Platforms left assembled for more than one year without maintenance may be difficult to disassemble.
• Monitor the system to make sure it functions properly and meets accuracy standards.
• Ensure mechanical parts show no damage, deterioration, or change in configuration.
• Ensure that all connectors are intact and sealed against moisture and that all are clean and dry.
• Ensure that platforms and cables show no sign of salt built up.
• Ensure there is no dirt or debris in the load cell trays or under the platforms.
• Ensure the pit is clean and drained (where applicable).
• Ensure all cables are intact and show no signs of pinching or cuts. Be sure splices are tightly sealed.
• Ensure all bolts and nuts tightened to proper torque.
• Ensure that operating personnel are familiar with the Rice Lake AX3040 systems safe and proper operation
and maintenance.
• Always use a non-corrosive anti-seize compound on all nuts and bolts when re-assembling the platforms.