Rice Lake 920i Installation Manual V3.13 - Manual (Page 99)

Serial Commands 93
SP.DACCEPT#n Accept digital output BITx
SP.DOVER#n Overrange digital output BITx
BATCHNG Batching mode OFF, AUTO, MANUAL
SP.ENABLE#n Setpoint enable ON, OFF
For setpoint commands ending with “#n”, n is the setpoint number.
Command Description Values
GFMT.FMT
GFMT.PORT Gross demand print format string For .PORT commands, specify the port number as PORTxx (no
leading zero). For example: GFMT.PORT=PORT3.
For AUXFMT.FMT commands, specify the auxiliary format number
(1—20) as AUXFMTxx (no leading zero). For example:
AUX8FMT=GROSS…
See Section 6.0 on page 59 for information about demand print
format strings.
See the iQUBE Installation Manual, PN 77224, for more information
about alert formats.
NFMT.FMT
NFMT.PORT Net demand print format string
ACC.FMT
ACC.PORT Accumulator print format string
SPFMT.FMT
SPFMT.PORT Setpoint print format string
TRWIN.FMT
TRWIN.PORT Truck weigh-in print format string
TRWOUT.FMT
TRWOUT.PORT Truck weigh-out print format string
TR.FMT
TR.PORT Truck register print format string
ALERT.FMT
ALERT.PORT Alert format string
HDRFMT1
HDRFMT2 Ticket header format strings
AUXFMTxx.FMT
AUXFMTxx.PORT Auxiliary ticket format
AUD.PORT Audit trail port
WDGT#n Display widget widget_number
See Section 9.2 on page 98 for widget programming information.
WDGT.CLR Clear widgets —
Table 9-7. PFORMT Serial Commands
Command Description Values
Table 9-6. SETPNTS Serial Commands (Continued)
Command Description Values
DON.b#s Set digital output on (active) at bit b, slot s. —
DOFF.b#s Set digital output off (inactive) at bit b, slot s. —
DIO.b#s Digital input function OFF, INPUT, OUTPUT, PROGIN, ZERO, NT/GRS,
TARE, UNITS, PRINT, ACCUM, SETPNT,
TIMDATE, ESC, CLEAR, DSPTAR, IDKEY,
KEY0–KEY9, KEYDP, ENTER, NAVUP, NAVDN,
NAVLFT, NAVRGT, KBDLOC, HOLD, BATRUN,
BATSTRT, BATPAUS, BATRESET, BATSTOP,
CLRCN, GROSS, NET, PRIM, SEC, CLRTAR,
CLRACC, TRIGGER
Table 9-8. DIG I/O Serial Commands