Rice Lake 920i FlexWeigh Systems - 102 - Manual (Page 15)

Modifying Auto Print 11
3.7 Modifying Auto Print
Use the following steps to modify the auto print.
1. From the Main Setup Menu Screen , press the More=> softkey to access the second setup menu screen
(Figure 3-8).
2. Press the Auto Print Enabled or Auto Print Disabled softkey. The system will toggle between the two modes
of operation.
Figure 3-9. Auto Print Disabled Softkey
3.8 Delay After Discharge
Use the following steps to modify the delay after discharge.
1. Cycle through pressing the More => softkey to access the third setup menu screen which includes the Delay
After Discharge softkey.
Figure 3-10. Delay After Discharge Softkey Location
2. Press the Delay After Discharge softkey to access that softkey.
Figure 3-11. Enter Time
3. Enter in the time in seconds to delay the discharge time.
Auto Print
Disabled
04/28/2011 02:15PM SCALE #1
Test
Digital IO
<= More
Setup Menu:
- - - - - - SCALE #1
Gross
Lb
SETUP MENU
Exit Delay After
Discharge
SETUP MENU
Program: Express 102 PN120597 (V 1.00)
ID #1 (disabled)
Start O Zero Tol
ID #2 (disabled) Resume O Fill Copt
Dual Speed (enabled) Reset O Slow Fill
Auto Tare (enabled) Stop O Fast Fill
Auto Print (disabled) Discharge O Discharge
Delay After Discharge (sec) :30
04/28/2011 02:15PM SCALE #1
Cancel Home
Delay After Discharge (sec):
=> .30
- - - - - - SCALE #1
Gross
Lb
SETUP MENU
End
SETUP MENU
Program: Express 102 PN120597 (V 1.00)
ID #1 (disabled) Start O Zero Tol
ID #2 (disabled) Resume O Fill Copt
Dual Speed (enabled) Reset O Slow Fill
Auto Tare (enabled) Stop O Fast Fill
Auto Print (disabled)
Discharge O Discharge
Delay After Discharge (sec) :30