Rice Lake 920i Programmable HMI Indicator/Controller - Profibus DP Interface - Manual (Page 16)

12 520/720i/820i/920i Profibus DP Installation and Programming Manual
4.0 GSD File
;=================================================================
; GSD-File for Profibus Indicator Interface
; Rice Lake Weighing Systems
;
; Version V0.4
;
; Date : 9/18/2002
; File : RLWS088B.GSD
;=================================================================
#Profibus_DP
;
GSD_Revision = 1 ; This file works with text readers.
Vendor_Name = "Rice Lake Weighing Systems"; Manufacturer's name
Model_Name = "Profibus Indicator Interface"; Equipment supported
Revision = "V1.2"; Version of the GSD file
Ident_Number = 0x088B; Profibus Device ID
Protocol_Ident= 0 ; Profibus DP protocol
Station_Type = 0 ; This is a slave device
FMS_supp = 0 ; No FMS support
Hardware_Release = "Serial REV B / Parallel Rev A"
Software_Release = "Serial v1.00 / Parallel v1.12";
9.6_supp = 1 ; These baud rates are supported
19.2_supp = 1
45.45_supp = 1
93.75_supp = 1
187.5_supp = 1
500_supp = 1
1.5M_supp = 1
3M_supp = 1
6M_supp = 1
12M_supp = 1
MaxTsdr_9.6 = 60 ; Time delay needed after a message is sent
MaxTsdr_19.2 = 60
MaxTsdr_45.45 = 250
MaxTsdr_93.75 = 60
MaxTsdr_187.5 = 60
MaxTsdr_500 = 100
MaxTsdr_1.5M = 150
MaxTsdr_3M = 250
MaxTsdr_6M = 450
MaxTsdr_12M = 800
Redundancy = 0 ; Redundancy not supported
Repeater_Ctrl_Sig = 2 ; Repeater control signal TTL
24V_Pins = 0 ; 24 V pins not connected
Implementation_Type= "SPC3"