QOMO QD700 - Manual (Page 19)

IMAGE SAVE AND RECALL
Press the “SAVE” button once to save one captured images, it can
save up to 7 images. After 7 images are saved, the 8
th
image will
replace the previous 1
st
image and will become the new 1
st
saved
image. (On the remote control)
Press the “RECALL” button once to display the saved images, then
press the numberical button to show the corresponding image. For
example: Press “2” to display the second image. At this status, the
function under each numeric key is not available. Press “RECALL”
again to exit this mode. (On the remote control)
INFRARED REMOTE CONTROL
The QD700’s remote control can control the camera from different
angels. Please note that an infrared remote control can only be used
up to a certain distance to the unit. Objects situated between the
visualizer and the infrared remote control and a weak battery may
interfere with the reception.
On the left side of the visualizer stage, there is a built-in remote
control storage compartment where you can store the remote control
when you not use it.
IMAGE SCROLLING
Press the “ ” button to scroll the image down to display the upper
part of the image. Press the “ ” button to scroll the image up to
display the lower part of the image.
USB PORT
The USB port can be used to transfer still images from the visualizer
to a computer. No additional computer hardware is required. In this
way, the visualizer can be used as a 3-D scanner for your computer.
Connect the visualizer to your computer with the supplied USB cable.
The visualizer software is available on the supplied CD-ROM.
19