QOMO QD700 - Manual (Page 17)

SWITCHABLE VIDEO INPUTS
Press the “S-VIDEO/VIDEO” button to switch among S-Video and
Video signals.
SWITCHABLE RGB INPUTS
Use the “CCD/PC1/PC2” button to switch among CCD and different
RGB signals. Each time the “CCD/PC1/PC2” button is pressed, it
provides seamless transitions among different sources such as
Camera (CCD)、COMPUTER(IN)、and RGB (IN).
Notes: RGB OUT always outputs RGB IN signals.
PROJECTOR ON/STANDBY
Press the “POWER” button to turn on the visualizer’s power and
press the “Ppw” button to turn the projector power on. To turn the
projector standby after use, press the “Ppw” button more than 2
seconds, and then the projector enters to the stand-by mode. (On the
remote control, press the “PROJECTOR POWER” button)
Note: Please connect the projector RS232 cable between the
projector and the visualizer first. If you cannot switch projector inputs
by pressing this button, you need to manually program the RS232
code into the visualizer. See the section “Controlling Projector with
Visualizer” for detailed instruction.
PROJECTOR INPUTS SELECTION
When the projector is connected to several input sources, use the
“Pin” button to switch signal inputs of the projector. (On the remote
control, press the “PROJECTOR INPUT” button)
Note: Please connect the projector RS232 cable between the
projector and the visualizer first. If you cannot switch projector inputs
by pressing this button, you need to manually program the RS232
code into the visualizer. See the section “Controlling Projector with
Visualizer” for detailed instruction.
17