Losi LOSB0112 - Manual (Page 7)

7 Losi XXX-sCB RTR • iNsTRuCTioN maNuaL
EN
Receiver
There is no adjustment required of the receiver. Please note the different slots for
connection.
The bind slot is used to bind the transmitter to the receiver. The bind process
teaches the transmitter the unique GUID ID of the receiver. Although the
transmitter and receiver come bound, below are the steps to rebind your
transmitter and receiver should the need arise.
Rebind Process
1. Ensure the transmitter and vehicle are both turned off.
2. Using the supplied Bind plug (which looks like a standard servo plug with a
short wire loop installed), insert the Bind plug into the receiver slot labeled
BIND.
Note: You do not need to remove any other plugs to rebind.
3. Connect a fully charged battery to the EC3 connector on the ESC.
4. With the Bind plug installed, turn on the vehicle. Notice the receiver LED is now
blinking.
5. Turn on the transmitter. You will see a similar blinking LED under a translucent
cover on the back of the transmitter.
6. Both the receiver and transmitter LEDs will stop blinking and be on solid,
indicating they are bound.
7. Turn off the vehicle and then the transmitter.
8. Remove the bind plug from the receiver.
9. Turn on the transmitter and then the vehicle to ensure operation. If the
transmitter does not control the vehicle, repeat steps 1 –8 above. If after
several attempts you are unsuccessful, please contact Horizon product
support.
Receiver Antenna
Using your fingers gently straighten the antenna wire to be close to vertical from
the chassis for the best radio reception.
Factory Settings of Radio/ESC
The Electronic Speed Control was calibrated together with the radio system at the
factory. When you turn on and run the XXX-SCB for the first time, you may need
to slightly adjust the Throttle Trim. If the vehicle creeps in reverse or in forward,
make a fine adjustment to the Throttle Trim knob on the transmitter. Sometimes
the bumps and bounces of transportation can slightly alter the settings.
auXiLiaRY CHaNNEL
THRoTTLE CHaNNEL
sTEERiNG CHaNNEL
BiND PoRT
Tuning, adjusting & maintaining Your Vehicle
• Examine your vehicle on a regular basis.
• Use a brush to remove dirt and dust.
• Look for damage to the suspension arms and other molded parts.
• Re-glue the tires to the wheels, if necessary.
• Use suitable tools to tighten fasteners.
• Make sure the camber and steering linkages are not bent. Replace any bent
linkages.
• Adjust the Toe and Camber settings, if necessary.
• Remove the shocks and inspect them for damage. Rebuild the shocks if oil is
leaking.
• Inspect electronics and batteries for exposed wires. Repair exposed wires with
shrink-wrap or replace the wire.
• Make sure the ESC and receiver are secure on the chassis. Replace the
double-sided tape, if necessary.
• Power on the transmitter. If the green LED is dim or off, replace the AA
batteries in your transmitter.
• Check the spur gear for wear.
service/Repair
Radio/Speed Control & Motor
If any problems other than those covered in the troubleshooting section arise,
please call the appropriate electronics service department. They will be able to
give the problem additional specific attention and provide instructions for the
solution.
Maintenance
If any questions other than those covered in the troubleshooting or maintenance
sections arise, please call the appropriate Horizon product support department.
Cleaning
Performance can be hindered if dirt gets in any of the moving suspension parts.
Use compressed air, a soft paintbrush, or a toothbrush to remove dust or dirt.
Avoid using solvents or chemicals as they can actually wash dirt into the bearings
or moving parts, as well as cause damage to the electronics.