Losi LOSB0112 - Manual (Page 4)

Losi XXX-sCB RTR • iNsTRuCTioN maNuaL 4
EN
D
B
a
E
C
F
G
A. Antenna
B. Dual Rate Adjustment (ST. D/R)
C. Steering Trim (ST. TRIM)
D. Power On/Off
E. Steering Wheel
F. Throttle Trim (TH. TRIM)
G. Throttle/Brake Trigger
1. Push in the battery cover
a small amount to release
the retaining tab, then
remove the cover.
2. Install 4 AA batteries,
taking care to align battery
polarity to the diagram in
the transmitter’s battery
case.
3. Carefully re-install the battery cover by aligning the tabs with the
slots on the transmitter.
CauTioN: Do not remove transmitter batteries while the model is
powered on or while operating as a loss of model control, damage
or injury can result.
Installing Batteries
The Transmitter
Driving Precautions
• Avoid driving the vehicle in or through standing water, wet grass, mud or snow.
The electronics in the vehicle are not waterproof.
• Maintain sight of the vehicle at all times.
• Inspect the vehicle for loose wheel hardware.
• Inspect the steering assembly for any loose hardware. Driving the vehicle off-
road can cause fasteners to loosen over time.
• Do not drive the vehicle in tall grass. Doing so can damage the vehicle or
electronics.
• Stop driving the vehicle when you notice a lack of power. Driving the vehicle
when the battery is discharged can cause the receiver to power off. You may
lose control of the vehicle.
CauTioN: Do not discharge a LiPo battery below 3V per cell.
Batteries discharged to a voltage lower than the lowest approved
voltage may become damaged, resulting in loss of performance and
potential fire when batteries are charged.
• Do not apply the throttle in forward or reverse if the vehicle is stuck. Applying
throttle in this instance can damage the motor or ESC.
• After driving the vehicle, allow the electronics to cool to ambient temperature
before using the next battery pack.