Bag g (continued) – Losi LOSA0095 Manual User Manual

Page 30

Text mode
Original mode

BAG G (Continued)

2 6

Figure 58

*Note: Posts are not to scale.

Table 57A

Table 57B

Step 9. Use Tables 57A and 57B to determine how the servo

mounting posts (146) should be attached to the servo

(not in-

cluded).

Trim any flashing from the pins on the mounting posts

so that they will seat all the way into the holes in the chassis
brace and chassis.

Step 10. Place a #4 washer (58) over each of the four

4-40 x 3/8" cap-head screws (17) and attach the servo posts (146)
to the servo by threading a screw (17) through the upper and
lower holes in each post (146). Do not tighten the screws (17)
yet! Just snug them up so that the posts are held in place, but can
still be moved from side to side with a little resistance. The screws
(17) will be tightened after the servo is installed so that the posts
(146) have the correct spacing.

146

Figure 58

Note: If you wish to use Futaba

or HiTech Radios you will

need LOSA1620