Chapter 3 configuration pb-tim2 user’s manual – Kontron PB-TIM2 User Manual
Page 20

Chapter 3 Configuration
PB-TIM2 User’s Manual
3.1.2 Output Electrical Specification
The three outputs are all optoisolated from the supply with a rating of 1500V. These channels use the common V+ and
V- supply rails and are equipped with an open collector circuitry that is capable of sourcing up to 200mA at a voltage
difference of 24V between the V+ and V- inputs. The outputs are inductive load protected and function correctly within a
voltage range between 5V and 30V.
3.1.3 MODPACK Timing Specifications
DTACK is generated on board and assuming a 16 MHz system clock and 4 MHz timer clock, is generated 5 cycles after
Chip Select and Data Strobes. This condition is valid for both read and write cycles.
Page 3-4
© 1996 PEP Modular Computers
July 30, 1997
See also other documents in the category Kontron Hardware:
- CP3003-SA uEFI BIOS (72 pages)
- CP3003-SA (36 pages)
- CP3002 (38 pages)
- CP3002-RC uEFI (64 pages)
- CP-RIO3-05 (42 pages)
- CP3002-RC (30 pages)
- CP342 (52 pages)
- CP930 (46 pages)
- CP932 (52 pages)
- CP346 (72 pages)
- CP384 (66 pages)
- CP383 (74 pages)
- CP382 (58 pages)
- CP381 (60 pages)
- CP372 (64 pages)
- CP371 (60 pages)
- CP-RIO3-04S (38 pages)
- CP390 (36 pages)
- CPS3410 (9 pages)
- CPS3402 (9 pages)
- CPS3105 (9 pages)
- CPS3101 (9 pages)
- CPS3003-SA (19 pages)
- PB-SIO4 (34 pages)
- PB-SIO4A (34 pages)
- PB-DOUT8 (34 pages)
- VMOD-2 (82 pages)
- VSBC-32 (110 pages)
- VM42 (62 pages)
- Bootstrap Loader (24 pages)
- VMP1 with Netbootloader (120 pages)
- VMP1 (106 pages)
- NetBootLoader (86 pages)
- VMP2 (142 pages)
- VMP3 (154 pages)
- CP-RIO6-923 (32 pages)
- CP-RIO6-923-F (32 pages)
- CP-RIO6-001 (28 pages)
- CP-RIO6-001-HD-VGA (46 pages)
- CP-RIO6-M (20 pages)
- CP-RIO6-B (28 pages)
- CP6925 (42 pages)
- CP6002 uEFI BIOS (76 pages)
- CP6002 IPMI (40 pages)
- CP6002 (42 pages)