Kontron KTT30-mITX - Manual (Page 7)

KTD-N0857-A Page 4 Installation
KTT30/mITX Users Guide
Warning: Turn off PSU (Power Supply Unit) completely (no mains power connected to the PSU) or leave
the Power connectors unconnected while configuring the board. Otherwise components (RAM, LAN
controller, SPI flash or others) might get damaged.
!
!
Warning: When mounting the board to chassis etc. please notice that the board contains components
on both sides of the PCB which can easily be damaged if board is handled without reasonable care. A
damaged component can result in malfunction or no function at all.
Do not use washers with teeth as they can damage the PCB and may cause short circuits.
2 Installation Procedure
2.1 Installing the Board
To get the board running follow these steps.
1.
Turn off the PSU (Power Supply Unit)
2.
Connecting Interfaces
Insert all external cables for a storage media, a keyboard or others. A serial connection to a desktop PC
must be etablished in order to be able to change Setup settings.
3. Connect and turn on PSU
Connect the PSU to the board and turn it on.
4. Power Button
The PWRBTN pins must be shortened to start the board; this is done by pin 10 (PWRBTN+) and pin 12
(PWRBTN-) on the FRONTPNL connector J7 (see chapter 'Power Supply').
5. Mounting the board to chassis
When fixing the Motherboard on a chassis it is recommended using screws with integrated washer and
having diameter of approx. 7mm.