Kontron KTT30-mITX - Manual (Page 20)

KTD-N0857-A Page 17 Rear Connectors
KTT30/mITX Users Guide
7.4 LAN Connector
The KTT30 uses an Intel ® 82574 Gigabit PCI Express ® LAN controller which supports 10/100/1000 Base-T
interfaces. The controller auto-negotiates the management of a 10, 100 or 1000 Mbps connection. Addi-
tionally you can boot up the board via a network connection from a PXE server.
The LAN interface is available through the standard RJ45 connector J8 (8 pins).
Header Pin Signal Description Type
1 TXD+ / MDIO1+ 10/100 transmit / 1000 pair 1 (positive) DSO / DSIO
2 TXD- / MDIO1- 10/100 transmit / 1000 pair 1 (negative) DSO / DSIO
3 RXD+ / MDIO2+ 10/100 receive / 1000 pair 2 (positive) DSI / DSIO
4 MDIO3+ 1000 pair 3 (positive) DSIO
5 MDIO3- 1000 pair 3 (negative) DSIO
6 RXD- / MDIO2- 10/100 receive / 1000 pair 2 (negative) DSI / DSIO
7 MDIO4+ 1000 pair 4 (positive) DSIO
8 MDIO4- 1000 pair 4 (negative) DSIO
7.5 Audio Interface
The SoC supports an Inter-IC Sound (I 2 S) codec with 24 bit resolution and 96 kHz sample rate (the
maximum rate of 96 kHz only unidirectional). The analogue-to-digital part of the codec uses 24 bit, 128x
oversampled sigma-delta ADCs. The digital-to-analogue part contains two 24 bit sigma-delta DACs. The
interface includes LINE OUT, LINE IN, MICROPHONE IN and a digital S/PDIF output.
7.6 Analog Connectors
The analog audio interface uses three TRS (Tip, Ring, Sleeve) connectors J9 to J11 (3 pins).
1
Parameter Values Units
Output resolution (LINE OUT, S/PDIF) 16/20/24 bit
Output sample rate (LINE OUT, S/PDIF) 44.1/48/96 kHz
Output signal-to-noise ratio (LINE OUT) 96 dB
Input resolution (LINE IN) 16/20/24 bit
Input sample rate (LINE IN) 44.1/48/96 kHz
Input signal-to-noise ratio (LINE IN) 92 dB
Header Pin J11
BLUE
J10
LIME
J9
PINK
Type
Tip LINEIN-L LINEOUT-L MIC-L IA resp. OA (J10)
Ring LINEIN-R LINEOUT-R MIC-R IA resp. OA (J10)
Sleeve GND GND GND PWR