Kontron KTA55-pITX - Manual (Page 53)

KTD-S0031-E Page 49 Appendix A: System Resources
KTA55/pITX User's Guide
A.2 Memory Area
The first 640 kB of DRAM are used as main memory. DOS can address 1 MB of memory directly. Memory area
above 1 MB (high memory, extended memory) is accessed under DOS via special drivers such as HIMEM.SYS.
Other operating systems (Linux or Windows
® versions) allow you to address the full memory area directly.
Memory Range Used for Available Comment
C0000h - CFFFFh VGA BIOS No
D0000h - FFFFFh System BIOS No
A.3 I/O Address Map
The I/O port addresses of the KTA55/pITX are functionally identical to a standard PC/AT. All addresses not
mentioned in this table should be available. We recommend that you do not use I/O addresses below 0100h
with additional hardware for compatibility reasons even though they are available.
I/O Address Used for Available Comment
0170h - 0177h S-ATA Controller (Legacy Mode) Yes Chipset Note (2)
01F0h - 01F7h S-ATA Controller (Legacy Mode) Yes Chipset Note (2)
0376h S-ATA Controller (Legacy Mode) Yes Chipset Note (2)
03B0h - 03DFh Graphic Controller No Chipset
03F6h S-ATA Controller (Legacy Mode) Yes Chipset Note (2)
0470h Software IRQ Register No Chipset
04D0h - 04D1h PIC Extension No Chipset
0600h - 06FFh TPM Controller No Chipset Note (1)
0800h - 0827h Power Management No Chipset
0A80h - 0A81h System Extension No CPLD
0B00h - 0B3Fh SMBus TM No Chipset
0C00h - 0C01h PIC Extension No Chipset
0CD0h - 0CDFh System Extension No Chipset
0CF8h - 0CFFh PCI Configuration No Chipset
E000h - E01Fh LAN Controller No Onboard PCI Express ® device Note (1)
F000h - F0FFh Graphic Controller No Chipset
F100h - F14Fh S-ATA Controller 2 No Chipset Note (1)
F150h - F19Fh S-ATA Controller 1 No Chipset Note (1)
FE00h Power Management No Chipset
Note: 1) If the Used for device is disabled in the BIOS Setup the corresponding I/O address is free.
2) Default mode is 'Native IDE'.