Kontron KTA55-pITX - Manual (Page 17)

KTD-S0031-E Page 13 Graphics Interface
KTA55/pITX User's Guide
6.2 Flat Panel Connector (JILI30)
The LVDS interface for the flat panel is available through the J1202 connector (30 pins) on the bottom side
of the board. This connector represents the JILI interface. The implementation of this subsystem complies
with the JILI specification of KONTRON Technology A/S. A variety of cables for different display types are
available from KONTRON. Please refer to the actual
Display Cable Guide on the same product web site.
Header Pin Signal Name Function
1 FTX0- First channel data output 0 (negative)
2 FTX0+ First channel data output 0 (positive)
3 FTX1- First channel data output 1 (negative)
4 FTX1+ First channel data output 1 (positive)
5 FTX2- First channel data output 2 (negative)
6 FTX2+ First channel data output 2 (positive)
7 GND Ground
8 FTXC- First channel clock output (negative)
9 FTXC+ First channel clock output (positive)
10 FTX3- First channel data output 3 (negative)
11 FTX3+ First channel data output 3 (positive)
12 STX0- Second channel data output 0 (negative)
13 STX0+ Second channel data output 0 (positive)
14 GND Ground
15 STX1- Second channel data output 1 (negative)
16 STX1+ Second channel data output 1 (positive)
17 GND Ground
18 STX2- Second channel data output 2 (negative)
19 STX2+ Second channel data output 2 (positive)
20 STXC- Second channel clock output (negative)
21 STXC+ Second channel clock output (positive)
22 STX3- Second channel data output 3 (negative)
23 STX3+ Second channel data output 3 (positive)
24 GND Ground
25 SDA I2C data line
26 DATAENA Panel power output
27 SCL I2C clock line
1
30
28 - 30 VCC 1) Power +3.3V or +5V