Kontron CP-RIO3-05 - Manual (Page 42)

Installation CP-RIO3-05
Page 3 - 6 ID 1044-0711, Rev. 1.0
P R E L I M I N A R Y
3.4 Installation of External Serial ATA Devices
Up to two external SATA devices may be connected to the CP-RIO3-05 via the onboard SATA
connectors J4 and J5 as well as the appropriate SATA cables.
Some symptoms of incorrectly installed SATA devices are:
• Device on a SATA channel does not spin up: check power cables and cabling. May also
result from a bad power supply or SATA device.
The SATA connector on the CP-RIO3-05 provides only a data connection. The power for
this device must be supplied by a separate connector. For further information, refer to
the respective documentation of the device.
• SATA device fail message at boot-up: may be a bad cable or lack of power going to the
drive.
Warning!
The incorrect connection of power or data cables may damage the SATA
device and/or the CP-RIO3-05.