Kontron CP-RIO3-05 - Manual (Page 40)

Installation CP-RIO3-05
Page 3 - 4 ID 1044-0711, Rev. 1.0
P R E L I M I N A R Y
3.2 Initial Installation Procedures
The following procedures are applicable only for the initial installation of the CP-RIO3-05 in a
system.
To perform an initial installation of both the CP-RIO3-05 in a system, proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed.
2. Ensure that the CP-RIO3-05 is compatible with the CPU board and the backplane prior
to installation.
3. If appropriate, ensure that the onboard peripheral devices are properly installed prior to
installation of the CP-RIO3-05.
4. Ensure that no power is applied to the system before proceeding.
5. Carefully insert the CP-RIO3-05 into the slot designated by the application requirements
for the CP-RIO3-05 until it makes contact with the backplane connector.
6. Using the ejector handle, engage the CP-RIO3-05 with the backplane. When the ejector
handle is locked, the CP-RIO3-05 is engaged.
7. Fasten the front panel retaining screws.
8. Connect all external interfacing cables to the CP-RIO3-05 as required.
9. Ensure that the CP-RIO3-05 and all required interfacing cables are properly secured.
The CP-RIO3-05 is now ready for initial operation.
Warning!
Failure to comply with the instruction below may cause damage to the
CP-RIO3-05 or result in improper system operation.
Warning!
Even though power may be removed from the system, the CP-RIO3-05
front panel cables may have power applied which comes from an external
source.
In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.
It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or inju-
ry to personnel which may arise from the handling of these cables (con-
necting or disconnecting).
Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.
Warning!
When performing the next step, DO NOT push the CP-RIO3-05 into the
backplane connector. Use the ejector handle to seat the CP-RIO3-05 into
the backplane connector.