Kontron CP-RIO3-05 - Manual (Page 41)

CP-RIO3-05 Installation
ID 1044-0711, Rev. 1.0 Page 3 - 5
P R E L I M I N A R Y
3.3 Standard Removal Procedures
To remove the CP-RIO3-05 proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed.
2. Ensure that no power is applied to the system before proceeding.
3. Disconnect any interfacing cables that may be connected to the CP-RIO3-05.
4. Unscrew the front panel retaining screws.
5. Disengage the CP-RIO3-05 from the backplane by first unlocking the ejection handle and
then by pressing the handle as required until the CP-RIO3-05 is disengaged.
6. After disengaging the CP-RIO3-05 from the backplane, pull it out of the slot.
7. Dispose of the CP-RIO3-05 as required.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP-RIO3-05 nor system boards are physically damaged by
the application of these procedures.
Warning!
Even though power may be removed from the system, the CP-RIO3-05
front panel cables may have power applied which comes from an external
source.
In addition, these cables may be connected to devices that can be dam-
aged by electrostatic discharging or short-circuiting of pins.
It is the responsibility of the system designer or integrator to ensure that
appropriate measures are taken to preclude damage to the system or inju-
ry to personnel which may arise from the handling of these cables (con-
necting or disconnecting).
Kontron disclaims all liability for damages or injuries resulting from failure
to comply with the above.