Kontron CP-RIO3-05 - Manual (Page 31)

CP-RIO3-05 Functional Description
ID 1044-0711, Rev. 1.0 Page 2 - 9
P R E L I M I N A R Y
2.1.5 General Purpose Input/Output Port
The CP-RIO3-05 module provides one general purpose input/output port with five general pur-
pose inputs and three general purpose outputs. The GPIO port is implemented as a 10-pin on-
board connector J10.
The following figure and table provide pinout information for the onboard GPIO connector J10.
Note ...
The GPI signals tolerate only 3.3 V signaling and the inputs have internal pull-
up resistors.
The GPI and GPO signals support LVTTL signaling.
Figure 2-6: GPIO Connector J10
J10
GPIO
1 9
10
2
Table 2-8: GPIO Connector J10 Pinout
PIN SIGNAL DESCRIPTION I/O
1 GPI0 General purpose input 0 I
2 GPO0 General purpose output 0 O
3 GPI1 General purpose input 1 I
4 GPO1 General purpose output 1 O
5 GPI2 General purpose input 2 I
6 GPO2 General purpose output 2 O
7 GPI3 General purpose input 3 I
8 3.3V 3.3V power --
9 GPI4 General purpose input 4 I
10 GND Signal ground --