Gastroback 40965 Design Food Processor Advanced - Manual (Page 11)

Ensure the internal pusher is inserted an locked within the food
pusher before using the food pusher.
8. To insert the internal pusher pay attention to the guiding pins on
the edge of the internal pusher and the line mark on the top of the
pusher. The food pusher has matching cannelures and a line mark
as well. Place the internal pusher inside the food pusher and turn
it until the line marks are facing each other.
WARNING: Do not push products into the feed chute with your
fingers or foreign objects. Always use the food pusher provided.
While proceeding do not push the food pusher too hard down.
WARNING: To refill the feed chute always remove the food pusher first.
8. Connect the power plug to a suitable wall power outlet.
9. Start the appliance pressing the ´ON` button. The motor starts working, the food
is getting processed and gathered at the base of the bowl. While proceeding do not
push the food pusher too hard down to avoid overloading the motor. If the motor stalls or
stucks during operation or if the fibre of the food blocks the blade, immediately turn
´OFF` the appliance and unplug the power cord. Check whether there is any obstruction
in the processing bowl, and remove it (see ‘Care and Cleaning`).
ATTENTION: Do not use the appliance in continuous operation for more than 4 minutes
to avoid overheating. If processing large quantities of food, regularly interrupt operation
and unplug the appliance for at least 1 minute, to let the motor cool down.
Important: The Food Processor is fitted with a safety thermal cut-out device and will
shut off in the event of overload. If this occurs, switch the appliance off and it will
automatically reset when cool.
10. You can continue to fill the feed chute as soon as the feed chute is empty.
ATTENTION: Never hold your face or other body parts over the feed chute when the
motor is running because little pieces of food could be thrown out of the feed chute.
WARNING: Do not overfill the processing bowl. Possibly, take some food out of the
processing bowl, using a wooden or plastic spoon, before starting the appliance again.
Note: Very stringily food can block the blades. In this case turn the appliance off, wait
for the disc to stop moving and remove the plug from the power outlet. Take off the lid
by turning it counterclockwise. Remove the disc. Rinse the disc thoroughly under running
water and remove food residues. Assemble the appliance and continue to operate.
11. As soon as the food has the right consistency turn the appliance ´OFF`. Always turn
the appliance ´OFF` and pull the plug when the appliance is not in use and you finished
the operation.
12. Empty the bowl. Clean the appliance in accordance to the instructions in chapter
‘Care and Cleaning`. Do not leave any food dry on the surfaces of the appliance.
11
O
40965_designfoodprozessoradvanced_manual_english.qxp 29.01.2008 12:16 Seite 11