Care and cleaning – Gastroback 42909 Smart Ice Cream Advanced Automatic User Manual

Page 17

care and cLeanIng

always ensure that the appliance is out of reach of young children. Always

switch off the appliance (START/STOP button), then unplug the appliance, and wait until the

appliance cooled down, before moving or cleaning the appliance. Do not attempt to move

the appliance during operation. Do not use any abrasive cleaners or corrosive chemicals

(e.g. bleach) for cleaning the appliance or any parts of it, to avoid damage to the surfaces.

Do not use any hard or sharp-edged objects for cleaning any surfaces of the appliance.

Additionally, particles derived from scoring pads could get into the interior of the appliance,

causing hazard due to overheating, fire and/or electric shock. Ensure to protect the appliance

against splashing water and moisture. Do not immerse the appliance, or power cord in water

or any other liquid, to avoid hazards due to electric shock and damage. Do not spill or drip

any liquids on or in these parts to avoid risk of fire and electric shock. do not clean the

appliance or the power cord in an automatic dishwasher. Do not use violence!

Ensure that the ice cream machine is turned off by pressing the POWER button. The ice

cream machine is off when the START | PAUSE button’s LED light is no longer illuminating

red. Remove the power plug from the power outlet. Allow the ice cream machine compressor

to cool completely before disassembling and cleaning.

cleaning the stainless steel housing

Wipe the exterior of the stainless steel housing and the LCD screen with a soft damp cloth.

Do not use a dry paper towel or cloth to clean the LCD screen, or use an abrasive cleanser

or metal scouring pad to clean any part of the ice cream machine as these will scratch the

surface.
note: Never immerse the stainless steel housing in water or place in the dishwasher. Take

care not to allow water or cleaning fluids to seep under the buttons or LCD screen on the

control panel.
note: To clean the ice cream chamber ensure that the appli-

ance is at room temperature. Wipe out with soapy water and

a soft damp cloth.
2.

If over-spill of cream, milk, chocolate etc. occurs in the interi-

or chamber, carefully remove using a soft, damp cloth.
3.

Let all surfaces dry thoroughly prior to inserting the power

plug into a power outlet.

cleaning the lid

The lid can be cleaned in warm soapy water, using a soft sponge. Do not use an abra-

sive cleanser or metal scouring pad as these will scratch the surface. Let all surfaces dry

thoroughly prior to placing into the ice cream machine.

cleaning the Ice cream Bowl

Fill the ice cream bowl up halfway with warm soapy water. A non-abrasive liquid cleanser

or mild spray solution may be used. Allow to stand for 10 - 20 minutes.
note: Ice Cream Bowl is NOT dishwasher safe.