Gastroback 41000 Design Mixer Advanced - Manual (Page 20)

7. Clean the lid and the refill lid with soapy water.
8. Rinse the blender jug, the lid, and the refill lid with clear water and dry the
units thoroughly and carefully with a cloth or l eave all parts dry naturally where they
are out of reach of young children.
Note: The blender jug is dishwasher safe.
Note:
The lid, refill lid and blade assembly housing are not dishwasher safe. Ensure
to remove the blade assembly housing and take the lid off the blender jug before placing
the blender jug into the dishwasher.
Disassembling the blender jug and removing stubborn residues
WARNING: The blade is very sharp! Do not touch the blade. To handle the blade,
always hold on to the blade assembly housing.
1. Take the blender jug off the motorblock and hold it over the sink. Remove the holder
turning it 1/4 of a turn clockwise. Take the holder off the blender jug and remove the blade.
ATTENTION: The blender jug might be connected really tight to the holder. Do not
use force unscrewing it.
2. Rinse all units in warm soapy water. Soak stubborn residues for a few minutes and
then remove them using a nylon washing brush or sponge. Do not cut yourself.
Beware not to damage the sealing ring. If you can not get the sealing ring clean or if it is
porous or damaged you have to replace it. Contact your vendor for replacement
units.
3. After cleaning rinse all parts with clear water and dry them carefully. You can also
l eave all parts dry naturally where they are out of reach of young children. When the
units are dry assemble the blender jug for storage or usage.
Cleaning the motorblock
WARNING: Do not place the appliance in an automatic dishwasher or pour boiling
water over it. Do not immerse the motor or power cord in any liquids or spill any liquids
on it or place the motor on wet surfaces. Always wipe off spilled liquids immediately.
Ensure that no water can run into the louvre. When liquids are spilled on the motor
housing, immediately unplug the appliance and dry the motor housing to avoid risk
of electric shock or fire. Do not attempt to operate the appliance, when liquids are
on or in the motor housing.
1. Always turn the appliance ´Off`, wait for the motor to stop completely, and
unplug the appliance from the power outlet before you start cleaning the motorblock.
2. Wipe the motor housing and power cord with a damp soft cloth. Take care not
to spill or drip water or any other liquids on the motor housing.
20