Gastroback 41000 Design Mixer Advanced - Manual (Page 19)

6. As soon as the motor stops moving you can take the blender jug off the motorblock
holding on to the handle. Take off the lid to check the consistency of the food or to
push down the food from the sides of the blender jug. You can fill in more ingredients
through the refill aperture. Turn the refill lid anticlockwise and lift it. After adding the
ingredients close the refill aperture, place the blender jug on the motorblock and make sure
it is securely locked. Turn ´On` the appliance. Process until the food has the favoured texture.
7. Turn the appliance ´Off` as soon as you are done with operating and take the
blender jug off the motorblock. You can pour out liquid foods.
IMPORTANT: Do not leave any food dry on the surfaces of the appliance. Always
clean the appliance right after use (see Care and Cleaning).
Care and Cleaning
WARNING: To avoid injury to persons and damage, always turn the appliance ´Off`,
wait for the motor to stop completely and unplug the appliance, immediately after
operation and before assembling/disassembling or cleaning the appliance.
WARNING: Ware oven gloves if processing hot food. Ensure not to get burned on
spilled over liquids or steam.
ATTENTION: Do not use abrasive cleaners, cleaning pads, corrosive chemicals
(disinfectants, bleach) or any sharp or hard objects (i.e. metal scouring pads) for clean-
ing, for this could damage the surfaces. Always handle the entire appliance with care
and without violence.
Cleaning the blender jug
1. Empty the blender jug and rise it with warm water.
2. Replace the blender jug on the motorblock and ensure it is securely locked into position.
3. Fill the blender jug with warm soapy water. The waterlevel should be high enough
to cover the blade with water but not too high to avoid run over liquids. Close the lid
and turn ´On` the motor on “5”. Let the motor run for a few seconds.
4. Turn the motor ´Off`, wait for the blade to stop moving and take the blender jug
off the motorblock.
5. Pull the plug out of the power outlet.
6. Take the lid off the blender jug and pour out the water. Stubborn residues you can
remove using a nylon washing brush or sponge.
WARNING: Pay attention not to cut yourself cleaning around the blade or clean-
ing the blade.
IMPORTANT: The blender jug should be clean now. For the case that there are
stubborn residues on the blender jug or the blade, disassemble the blender jug and
clean the single unit (see ´Assembling and disassembling the appliance`). Soak the
units in warm soapy water.
19