Gastroback 41000 Design Mixer Advanced - Manual (Page 10)

Assembling and disassembling the appliance
Disassembling the blender jug
1. Always turn the appliance ´Off` (all buttons are deactivated), wait
until the motor stops and unplug the appliance before assembling/
disassembling. Always completely assemble your appliance
before you put the plug into the power outlet.
2. Remove the blender jug from the motor base by grasping the
handle and lifting the jug in an upward direction.
3. Take the lid off the blender jug and empty the blender jug
(picture A).
4. Take the clear refill lid and twist it anticlockwise to take it out.
NOTE: The refill lid has two small guiding pins that fit in the
matching gaps of the lid. Pull the inner lid up to remove it (picture B).
5. Remove the blade assembly housing by upturning the blender
jug and twisting the Blade Removal System clockwise to unlock
(picture C and D), then lift upwards and away from the base of
the blender jug.
ATTENTION: The circular plastic surround attached to the base
of the blender jug is not removable.
ATTENTION: The circular plastic surround attached to the
blades is not removable.
WARNING: The blades are very sharp. Pay attention handling
it and if possible only hold on to the blade assembly housing.
6. Remove the silicon seal from the blade assembly housing for
cleaning (picture E).
7. Clean the units with a soft sponge in warm soapy water and dry
them off afterwards. Pay attention not cutting yourself handling
the blade. Do not use abrasive cleaners, cleaning pads, corrosive
chemicals (disinfectants, bleach) or any sharp or hard objects
(i.e. metal scouring pads) for cleaning, for this could damage the
surfaces. Always handle the entire appliance with care and
without violence.
10
A
C
D
E
B