Gastroback 41001 Design Mixer Advanced Electronic - Manual (Page 21)

61
Disassembling the Blender Jug and removing stubborn residues
wArnIng:
The blade is very sharp! Do not touch the blade. To handle the blade,
always hold on to the blade assembly housing.
1.
Take the blender jug off the motorblock and hold it over the sink. Remove the holder turn-
ing it ¼ of a turn clockwise. Take the holder off the blender jug and remove the blade.
AttentIon: The blender jug might be connected really tight to the holder. Do not use
force unscrewing it.
2.
Rinse all parts in warm soapy water. Soak stubborn residues for a few minutes and then
remove them using a nylon washing brush or sponge. Do not cut yourself. Beware not to
damage the sealing ring. If you can not get the sealing ring clean or if it is porous or dam-
aged you have to replace it. Contact your vendor for replacement parts.
3.
After cleaning rinse all parts with clear water and dry them carefully. You can also leave
all parts dry naturally where they are out of reach of young children. When the parts are
dry assemble the blender jug for storage or usage.
cleaning the Motorblock
wArnIng:
Do not place the appliance in an automatic dishwasher or pour boiling
water over it. Do not immerse the motor or power cord in any liquids or spill any liquids on
it or place the motor on wet surfaces. Always wipe off spilled liquids immediately. Ensure
that no water can run into the louvre. When liquids are spilled on the motor housing, imme-
diately unplug the appliance and dry the motor housing to avoid risk of electric shock or
fire. Do not attempt to operate the appliance, when liquids are on or in the motor housing.
1.
Always turn the appliance off, wait for the motor to stop completely, and unplug the appli-
ance from the power outlet before you start cleaning the motorblock.
2.
Wipe the motor housing and power cord with a damp soft cloth. Take care not to spill or
drip water or any other liquids on the motor housing.
AttentIon: Ensure not to damage the drive gear. Never poke with anything into the
motorblock. If necessary use a soft brush for cleaning. If any liquids run into the motorblock
clean and dry the motorblock very carefully.
3.
Thoroughly dry the motor housing after each cleaning or leave it dry naturally where it is
out of reach of young children. Afterwards assemble the appliance.
Attendance:
You do not need to oil the motor. Clean the parts only as described in the
instructions.
wArnIng: Return the entire appliance (including all parts and accessories) to an author-
ised service centre for examination and repair.
storAge
Always clean the appliance before storing (see ›Care and Cleaning‹). Ensure to store the
appliance where it is clean, dry and safe from frost, direct sunlight and inadmissible strain
(mechanical or electric shock, heat, moisture) and where it is out of reach of young children.
Place the appliance on a clean and stable surface, where it can not fall. Do not place any
hard or heavy objects on the appliance. To avoid touching the blade unintentionally or