Gastroback 41001 Design Mixer Advanced Electronic User Manual

Page 13

base (picture G and H). Twist the Blade Removal System anticlockwise

until firmly locked into position.

wArnIng:

The blades are very sharp. Pay attention handling it

and if possible only hold on to the blade assembly housing.
note: The blade assembly housing has two small guiding pins that

fit in the matching gaps of the base of the blender jug. The blade

assembly housing is in the right position if it seats solidly onto the base

of the blender jug and when you can twist it anticlockwise.
note: Ensure the blade assembly housing is securely locked onto

the jug base.
The blade assembly housing and the sealing ring should be properly

connected to seal the bottom of the blender jug. Otherwise ingredi-

ents will run right into the motorblock.
IMportAnt: Do not tighten them with force or too tight to avoid

damaging the appliance or the sealing ring. Ensure the sealing ring

is in position and did not fall into the blender jug when assembling.
AttentIon: Ensure the blender jug is leak-proof before putting the

blender jug on the motorblock. Always wipe off spilled liquids imme-

diately. Never let any liquids run into the motorblock or underneath it

to avoid electric shock. When liquids are spilled on the motor hous-

ing, immediately unplug the appliance and dry the motor housing to

avoid risk of electric shock or fire. Do not attempt to operate the

appliance, when liquids are on or in the motor housing.
AttentIon: Never place the holder or the blade only on the motor-

block. Never touch the drive gear when the plug is connected to the

power outlet. Without the blade assembly housing the bottom of the

blender jug is open. Spilled liquids might run right into the motor.
AttentIon: When liquids are spilled on the motor housing, imme-

diately unplug the appliance and dry the motor housing to avoid risk

of electric shock or fire. Do not attempt to operate the appliance,

when liquids are on or in the motor housing.
3

. Place the proper assembled blender jug onto the motorblock. Turn

the blender jug until it locks onto the motorblock. The handle of the

blender jug should be positioned to the right hand side of the appli-

ance in order to see the measuring scale (picture I).
The screen will turn on as soon as the plug is plugged into the power outlet, the blender

jug is securely locked onto the motorblock and the appliance is switched on by pressing

the power button.
4.

Place the clear refill lid onto the opening of the blender lid.

note: The refill lid has two small guiding pins that fit in the matching gaps of the lid. Twist

it clockwise ¼ of a turn until firmly locked into position (picture J). You can hear it click when

the refill lid is in proper position.
5.

Load the blender jug with ingredients, pick a speed on the control panel and start processing.