Gastroback 41001 Design Mixer Advanced Electronic User Manual

Page 19

Place one hand on top of the lid. Press the Power-button on the far left of the control panel

to turn the blender on. The Power-button will illuminate and flash. The LCD timer screen will

illuminate with ›00‹ displayed.
4.

Select the required speed (1 to 5) by pressing the corresponding speed button. The

blender will start to operate and the selected speed button will illuminate. The Power-button

will illuminate and cease to flash. The STOP-button will illuminate and flash. The LCD timer

screen will start counting upwards in one second increments until 120 seconds is reached.
note: Using the pre-programmed functions such as the ICE-CRUSH or the SMOOTHIE

button the screen will start counting downwards in one second increments until ›00‹ is

displayed. When ›00‹ seconds is reached, the blender will automatically cease to operate.

The ICE-CRUSH button is pre-programmed for 30 seconds and the SMOOTHIE button for

40 seconds.
IMportAnt: The maximum amount of ice cubes the blender can blend at any one time is

1 standard ice tray or 250g.
note: The Pulse button is a touch sensitive button which keeps the motor running only for

the time you press the button down and which should be pressed in short intervals only.

One interval takes 1 second.
note: The speed can be changed at any time during the blending process. Each time a

new speed is selected its button will illuminate and the previous speed button illumination

will go out. The number of seconds on the LCD timer screen is not interrupted and will con-

tinue to count upwards to 120 seconds unless interrupted. If changing to a pre-programme

function the LCD timer screen resets to the pre-programmed function time selected.
AttentIon: If the motor slows down or stucks turn the appliance off imme-
diately to avoid overheating (see ›Trouble shooting‹).

Turn the appliance off when the operation is finished.

note: Operate the blender only for the appropriate amount of time required – do not over

process.
To stop blending at any time, press the STOP-button or the selected speed button. The

selected speedcontrol button and STOP-button illumination will go out and the Power-button

starts flashing. The appliance is set into the operational mode.
note: The Power-button can also be pressed, but this will also turn the appliance off and

all illuminations will go out.
Important: The blender will automatically stop blending after 120 seconds (2 minutes) and

the function button and STOP-button illumination will go out. The Power-button will illuminate

and flash. This is a safety feature.
6.

As soon as the motor stops moving you can take the blender jug off the motorblock hold-

ing on to the handle. Take off the lid to check the consistency of the food or to push down

the food from the sides of the blender jug. You can fill in more ingredients through the refill

aperture. Turn the refill lid anticlockwise and lift it. After adding the ingredients close the

refill aperture, place the blender jug on the motorblock and make sure it is securely locked.

Turn on the appliance. Process until the food has the favoured texture.