Cisco 340 User Manual
Page 58
5-58
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-08
Chapter 5 Configuring the Client Adapter
Setting Network Security Parameters
Enabling PEAP
Follow these steps to enable PEAP.
Step 1
For EAP type, choose PEAP.
Step 2
Click Properties. The PEAP Properties screen appears (see
).
Figure 5-17 PEAP Properties Screen
Step 3
Check the Validate server certificate check box if server certificate validation is required
(recommended).
Step 4
If you want to specify the name of the server to connect to, check the Connect only if server name ends
with check box and enter the appropriate server name suffix in the field below.
Note
If you enter a server name and the client adapter connects to a server that does not match the
name you entered, you are prompted to accept or cancel the connection during the authentication
process.
Note
If you leave this field blank, the server name is not verified, and a connection is established as
long as the certificate is valid.