Archived 4/2/10 – ETS-Lindgren FP5000 Isotropic Electric Field Probe (Archived) User Manual

Page 9

Isotropic Electric Field Probe
HI-4422/FP2000/FP4000/FP5000

2.0 GETTING STARTED

ACCEPTANCE AND CONTROLS

UNPACKING AND ACCEPTANCE

Step 1. Upon delivery of your order, inspect the shipping
container(s) for evidence of damage. Record any damage on
the delivery receipt before signing. In case of concealed
damage or loss, retain the packing materials for inspection by
the carrier.

Step 2. Remove the probe from its shipping containers. Save
the boxes and any protective packing materials for future use.

Step 3. Check all materials against the packing list to verify that
the equipment received matches that, which was ordered. If you
find any discrepancies, note them and call ETS-Lindgren
Customer Service for further instructions.

Be sure that you are satisfied with the contents of your order and
the condition of your equipment before installing the probe.

PROBE

A switch, two fiber optic connectors and a battery charger
connector are mounted on the HI-4422/FP2000/FP4000/FP5000
probe housing (Figure 3-1).

Archived 4/2/10

This manual is related to the following products:

FP4000 Isotropic Electric Field Probe (Archived) FP2000 Isotropic Electric Field Probe (Archived)