Archived 4/2/10 – ETS-Lindgren FP5000 Isotropic Electric Field Probe (Archived) User Manual

Page 21

Isotropic Electric Field Probe
HI-4422/FP2000/FP4000/FP5000

RETURN PROCEDURES

To return a probe to ETS-Lindgren, use the following procedure:

Step 1. Briefly describe the problem in writing. Give details
regarding the observed symptom(s), and whether the problem is
constant or intermittent in nature. If you have talked previously
to ETS-Lindgren Customer Service about the problem, provide
the date(s), the name of the service representative you spoke
with, and the nature of the conversation. Include the serial
number of the item being returned.

Step 2. Package the probe carefully. Use the original boxes and
packing materials, if possible. If not, use the Parts List in Table 1
to order new boxes and foam packing from ETS-Lindgren.

If the probe is still under warranty, refer to the Limited Warranty
at the front of this manual for additional information about your
return.

PERIODIC/PREVENTIVE MAINTENANCE

ETS-Lindgren recommends an annual calibration check of the
HI-4422/FP2000/FP4000/FP5000 probe to verify that it is
performing within specifications. ETS-Lindgren Service
Personnel at the factory may perform this calibration check.
Return your probe(s), using the original packing materials (if
possible), to:

ETS-Lindgren

1301 Arrow Point Drive

Cedar Park, TX, USA 78613

Tel: +1 512-531-6400

Fax: +1 512-531-6500

Archived 4/2/10

This manual is related to the following products:

FP4000 Isotropic Electric Field Probe (Archived) FP2000 Isotropic Electric Field Probe (Archived)