Archived 4/2/10, 0 appendix b: operating protocols – ETS-Lindgren FP5000 Isotropic Electric Field Probe (Archived) User Manual

Page 29

Isotropic Electric Field Probe
HI-4422/FP2000/FP4000/FP5000

7.0 APPENDIX B: OPERATING

PROTOCOLS

The information in this appendix assumes that you have
purchased the optional HI-4413P Fiber Optic/RS232 Interface,
and are capable of communicating directly with the
HI-4422/FP4000/FP5000 probe.

NOTE: The FP2000 is excluded from this
section. The FP2000 Firmware is designed to
operate with the FM2000 and FM5000 only.
The following protocol information does not
apply to this product. If further information is
required, please contact ETS-Lindgren
Customer Service at +1.512.531.6400.

COMMUNICATION PROTOCOL

Data Type:

RS-232 Serial

Data Mode:

Asynchronous

Word Length:

7 bit

Parity:

Odd

Stop Bits:

Data Rate:

9600 baud

INFORMATION TRANSFER PROTOCOL

The HI-4422/FP4000/FP5000 responds to commands from
another device; it transmits no data without first receiving
instructions to do so.

Archived 4/2/10

This manual is related to the following products:

FP4000 Isotropic Electric Field Probe (Archived) FP2000 Isotropic Electric Field Probe (Archived)