ETS-Lindgren FP5000 Isotropic Electric Field Probe (Archived) - Manual (Page 40)

Isotropic Electric Field Probe
HI-4422/FP2000/FP4000/FP5000
© ETS-LINDGREN L.P. – July, 2005
Revision G- Part # H-600054
40
1. General Safety Considerations
This symbol alerts the user that important
literature concerning the operation and
maintenance of this unit has been included.
Therefore, it should be read carefully in
order to avoid any problems.
This is a Safety Class I product (provided
with a protective earthing ground
incorporated in the power cord). The
mains plug shall only be inserted in a
socket outlet provided with a protective
earth contact. Any interruption of the
protective conductor, inside or outside the
instrument, is likely to make the instrument
dangerous. Intentional interruption is
prohibited. DO NOT defeat the earth-
grounding protection by using an extension
cable, power cable, or autotransformer
without a protective ground conductor.
This instrument is to be used with a three-
wire power cord set which meets or
exceeds the requirements of EN60799.
The power cord set used must be rated for
a minimum of 250V/10A. When connected
to an appropriate power line outlet, this
cable grounds the instrument cabinet.
No operator serviceable parts exist inside
the device. Refer servicing to qualified
personnel. To prevent electrical shock, do
not remove cover.
If this instrument is used in a manner not
specified by ETS-Lindgren, the protection
provided by the instrument may be
impaired.
This battery charger incorporates parts,
such as a switch and relay that potentially
could produce sparks or arcs.
For indoor use only, do not expose to rain.
Archived 4/2/10