Elecraft KBT2 - Manual (Page 2)

2
Installation
CAUTION: The battery is supplied charged. To prevent shorts during assembly, cover the (+)
terminal of the battery with tape immediately after removing it from the shipping box.
Identify all of the components in the kit using the parts list below. If anything is missing or damaged,
contact Elecraft.
Qty Description Part Number, Source
1 2.9 AH rechargeable battery PS-1229, PowerSonic
1 K2 internal battery bracket 100077, Elecraft
1 SPST power slide switch V701-13-SS-05-Q, C & K
1 2-pin male header, 0.156” (4 mm), gold WM5224, Digikey
1 2-pin female housing, 0.156” (4 mm), gold WM2111, Digikey
2 crimp pin, gold WM2305, Digikey
1 shottky diode, 5 A SB530CT-ND, Digikey
1 Resistor, 6.2 ohm, 2 W, 5% P6.2W-2BK-ND, Digikey
2 FASTON terminal A0907, Digikey
1' (30 cm) 20 AWG stranded wire, black C2040B, Digikey
2' (60 cm) 20 AWG stranded wire, red C2040R, Digikey
4 3” (8 cm) cable tie RP101, Digikey
4” (10 cm) Heat-shrink tubing, 0.25” (6.4 mm) OD CP014, Digikey
2 0.25” (6.4 mm) 4-40 thd hex M/F standoff 8714K, Digikey
2 4-40 x 3/8” (9.5 mm) machine screw, black Olander
2 4-40 x 1/4” (6 mm) machine screw, black Olander
2 #4 internal-tooth lock washer Olander
2 4-40 hex nut Olander
1 Foam pad, .050 x 2 x 6” (0.13 x 5 x 15 cm) Elecraft