EFCO S5500 Outside Glazed User Manual

Page 38

EFCO CORPORATION 6/2012

PART NO. Y550

Series 5500 Outside Glazed Installation Instructions

Section VII: Door Framing Installation & Anchorage

STEP #2 ANCHOR FIRST DOOR JAMB

The frame directly adjacent to the door opening will have the first door jamb. This jamb is 3/4” longer

than the typical mullions and extends below the sill down to the top of the floor slab. To maintain Exte-

rior sealant line, apply silicone to the interior surfaces of the door jamb and tool to the condition. The
door frame mullions and anchor clips are shown with the minimum amount of anchor bolts required, for

the purposes of the illustrations. The size, type, spacing, and quantities should be determined on a job-

by-job basis by the responsible engineer.

A. Note: The anchor clip must be slid into the door jamb

before

the frame is secured into the

opening. Ensure the clip is flush with the bottom of the mullion and the top of the condition.

Attach the anchor clip to the door jamb with screws as shown.

B. Drill anchor bolt holes through the clip and into the substrate as required.

Bolt the anchor clip to the condition.

DOOR JAMB

ANCHOR BOLTS

AS REQUIRED

ANCHOR CLIP

ATTACHMENT

SCREWS

Seal and Tool interior of Door

jamb to the condition