Dynojet Snowmobile Dynos: Installation Guide - Manual (Page 23)

Document # 98260100 3-5
Installing the Driver Carriage
Step 1
Remove the rear suspension as per manufacturers
instructions.
Step 2
Due to the varying widths of tunnels, it will be
necessary to measure the width between the
suspension mounting holes.
Step 3
Using the measurements, you must lengthen or
shorten the adjustable rods on the Driver
Carriage.
Remove the adjustable rods by loosening the set
screw and “popping” them out with a punch. Be
careful that you don’t damage the threads on
the adjustable rods!
Front Carriage
Mount
Set Screw