Dynojet Snowmobile Dynos: Installation Guide - Manual (Page 12)

1 - 8 Document #98260100
The cover should be removed every 300 runs
to ensure the brake is properly adjusted (see
next page) and to check the internal
components for wear.
Use the brake adjustment bolt on the left (shown
below) to adjust the Left side brake pad. Loosen
the lock nut and screw the adjuster bolt in so
that the clearance between the brake pad and
the disk is 0.0500". Tighten the lock nut. Do the
same to the right side. Check the brake fluid
and fill if necessary.
Brake Adjustment Screws
Left Right