Dynojet Snowmobile Dynos: Installation Guide - Manual (Page 21)

Document # 98260100 3-3
Step 2
Mount the Rear Carriage Mount to the Carriage
Frame with the (6) 3/8” allen head bolts. The
backing plates that the bolts thread into have a
left and right side.
The holes are offset to one side, this
is the side that should be closest to
the outside on the Carriage Frame.
Backing plates
Offset holes
towards outside Offset holes
towards outside
Note: The Rear Carriage Mount can be mounted
in two different configurations depending
on your snowmobile. See next page for
applications.