Dave Smith Instruments MOPHO SE - Manual (Page 51)

45
MIDI Messages
System Real-time Messages
Status Description
1111 1000 MIDI Timing Clock
Received Channel Messages
Status Second Third Description
1000 nnnn 0kkkkkkk 0vvvvvvv Note Off. Velocity is ignored
1001 nnnn 0kkkkkkk 0vvvvvvv Note On. Note off if vvvvvvv = 0
1010 nnnn 0kkkkkkk 0vvvvvvv Polyphonic Key Pressure
1011 nnnn 0vvvvvvv 0vvvvvvv Control Change; see “Received Controller
Messages” table following
1100 nnnn 0ppppppp Program change, 0-127 for Programs 1-128
within current Bank
1101 nnnn 0vvvvvvv Channel Pressure
1110 nnnn 0vvvvvvv 0vvvvvvv Pitch Bend LS Byte then MS Byte
Notes: 0kkkkkkk Note number 0 — 127
nnnn Channel number 0 to 15 (MIDI channel 1-16). Ignored if MIDI
channel set to ALL
0vvvvvvv Value
Received Controller Messages
Status Second Third Description
1011 nnnn 1 0vvvvvvv Mod Wheel — directly assignable controller
1011 nnnn 2 0vvvvvvv Breath Controller — directly assignable controller
1011 nnnn 4 0vvvvvvv Foot Controller — directly assignable controller
1011 nnnn 7 0vvvvvvv Volume — Combined with Master Volume and
Voice Volume
1011 nnnn 74 0vvvvvvv Brightness — Added to low-pass filter cutoff
frequency
1011 nnnn 11 0vvvvvvv Expression Controller — directly assignable
controller
1011 nnnn 32 0vvvvvvv Bank Select — 0 - 2 select banks 1 - 3; others
ignored
1011 nnnn 64 0vvvvvvv Damper pedal — holds envelopes in Sustain if
0100 0000 or higher
1011 nnnn 123 0vvvvvvv All Notes Off — clear all MIDI notes
1011 nnnn 121 0vvvvvvv Reset All Controllers — clears all MIDI
controllers to 0, MIDI volume to maximum
See sections below for additional Continuous Controller (CC) and Non-
registered Parameter Number (NRPN) messages received.