Dave Smith Instruments MOPHO SE - Manual (Page 36)

30
playing additional notes while latched adds them to the notes already playing. In
ReLatch mode, removing your hands from all keys and then playing an
additional note or notes causes the latched notes to be released and the newly
played note(s) to be latched on. As long as at least one key is held, pressing
additional keys will add to the arpeggio.
The Arpeggiator can also be latched with a footswitch connected to the Sustain
jack. See “Sustain” in Global Parameters on page 9.
The Arpeggiator (and Sequencer) can also sync to MIDI clock from an external
sequencer or other device. See “Clock” in Global Parameters on page 9 for
more information.
Sequencer —Turns Mopho’s gated sequencer on and off. See Sequencer on
page 21 for more information.
BPM: 30…250— Sets the tempo for the sequencer in BPM (beats per minute).
The accompanying light flashes on the beat. When syncing to an external MIDI
clock source, the BPM control has no effect.
Clock Divide— Sets the note value for each sequencer or arpeggiator step
relative to the BPM. Also affects the LFO frequency when LFO Clock Sync is
on. Clock Divide works with both internal and external clock sources. The
following table lists the Clock Divide values.
Display Tempo Timing Division
Half BPM/2 Half note
Quartr BPM Quarter note
Eighth BPM x 2 Eighth note
8 half BPM x 2 Eighth note, half swing timing
8swing BPM x 2 Eighth note, full swing timing
8 trip BPM x 3 Eighth note triplets
16th BPM x 4 Sixteenth note
16half BPM x 4 Sixteenth note, half swing timing
16swng BPM x 4 Sixteenth note, full swing timing
16trip BPM x 6 Sixteenth note triplets
32nd BPM x 8 Thirty-second note
32trip BPM x 12 Thirty-second note triplets
64trip BPM x 24 Sixty-fourth note triplets
Note: BPM is based on quarter notes, so clock divisions are relative to a
quarter-note beat. For example, when Clock Divide is set to Eighth, two
notes or steps will play per beat.