Dave Smith Instruments MOPHO SE - Manual (Page 37)

31
Miscellaneous Parameters
Miscellaneous Parameters groups together programmable parameters that do not
conveniently fall into any obvious section or, if they do, are parameters that are
less frequently used. They are important, but generally not required for
performance.
Voice Volume: 0…127— Sets the volume of the current program to match
volumes between programs.
Note: There is enough gain in the synth voice that with some settings,
some mild clipping distortion may be heard. If this happens, try lowering
the Voice Volume, and/or the Amp Envelope Amount (or Amp Envelope
Velocity).
Name —The lower line of the LCD displays the name of the current program.
Use the Name parameter to edit the name. When Name is selected, a character
blinks to indicate that it is active. To edit the character, use the Value knob, the
Param 2 knob, or the +/Yes or -/No switches. Use the Param 1 knob to edit
another character.
Oscillator Sync
,
Keyboard Tracking
,
Slop
,
Glide Mode
,
Pitch Wheel Range
,
and Key Assign are described under “Other Oscillator Parameters” in
Oscillators on page 14.
Sequence Trigger isdescribed under “Sequence Trigger Modes” in Sequencer
on page 25.
Arpeggiator Mode is part of the Arpeggiator description in Clock on page 29.
Envelope 3 Destination and Envelope 3 Repeat are described under “Other
Envelope Parameters” in Envelopes on page 18.
VCA Level: 0…127— Sets a base level for the VCA (Voltage Controlled
Amplifier). This essentially allows the VCA to be bypassed for programs that
drone.
Note: If VCA Level is on full, Envelope Amount has no effect. For
normal operation from the keyboard, VCA Level should be set to 0. For