Dave Smith Instruments PROPHET 12 DESKTOP - Manual (Page 20)

8 Global Settings Dave Smith Instruments
Global Settings
Press g
loBal
to set those parameters, such as Master Tune and MIDI Channel,
which affect all programs globally.
1 . Master Coarse Tune: -12…+12— Master Transpose control, 0 is centered.
Steps in semitones as much as one octave up (+12) or down (-12).
2 . Master Fine Tune: -50…+50— Master Fine Tune control; 0 centered. Steps
in cents as much as a quarter-tone up (+50) or down (-50).
3 . MIDI Channel: All, 1…16— Selects which MIDI channel to send and
receive data, 1 to 16. All receives on all 16 channels.
4 . MIDI Multi Mode: Off, On— Allows the A & B layers to be controlled by
separate MIDI channels. When On, the MIDI channel for layer B will be channel
(A+1) and shown in parenthesis, i.e. 1(B:2) in the MIDI channel display (above).
5 . MIDI Clock Mode: See table— Sets the Prophet 12’s ability to send and
receive MIDI clock messages.
Display MIDI Clock Setting
Off MIDI Clock is neither sent nor received.
Master MIDI Clock is sent, but not received.
Slave MIDI Clock is received, but not sent.
Slave Thru MIDI Clock is received and passed to MIDI Out.
Note: In Slave and Slave Thru modes, if no MIDI clock is present at the
selected input, the arpeggiator will not function.
6 . MIDI Clock Cable: MIDI Port, USB— Sets the port, MIDI or USB, by
which MIDI clocks are received.
7 . MIDI Param Send: Off, CC NRPN— Changes to the values of front panel
controls are transmitted via MIDI as Non-registered Parameter Number (NRPN)
controllers or as Continuous Controllers (CC). Transmission of parameters can
also be turned off. See MIDI Implementation on page 55 for details.
Note: NRPNs are the preferred method of parameter transmission, since they
cover the complete range of all parameters, while CCs are limited to a range
of 128.