Dataram DRHXW9300 - Manual (Page 2)

MEMORY REMOVAL
Note: Refer to your system owner’s manual for detailed instructions. MEMORY INSTALLATION
3.
Open both ejector levers on each slot.
4. Position a module over the slot so that the alignment notches on the
DIMM match the notches on the connector.
Caution: System parts are sensitive to electrostatic discharge and can be
damaged by the static charge you may carry. You should wear a
grounded wrist strap.
5.
Press firmly with your thumbs on both top ends of the module, applying
equal pressure until the module snaps into place. Lock the module in the
socket by pushing up on the ejector levers until they are in their upright
position.
1.
Single processor models will utilize DIMM pairs 1 and 3 only. The first
pair of modules is to be installed in DIMM pair 1 (blue sockets) and the
second pair in DIMM pair 3 (black sockets).
2. Dual processor models will utilize all four DIMM pairs. The first pair of
modules is to be installed in DIMM pair 1 (blue sockets), the second pair
in DIMM pair 2 (blue sockets), the third pair in DIMM pair 3 (black
sockets) and the fourth in DIMM pair 4 (black sockets).
Caution: Confirm the modules are fully and evenly seated in the slots.
Improper seating can cause electrical shorts that can damage
the memory and/or the system.
6.
Continue to install the remaining memory modules until you have filled
the bank with two identical modules. Repeat the above steps for each
bank of memory you wish to install.
7.
Reconnect the power cords and external cables, and turn on the system.
8. After you reboot, ensure the system recognizes the new memory
configuration.
MEMORY REMOVAL MEMORY INSTALLATION
Note: Refer to your system owner’s manual for detailed instructions. 3. Open both ejector levers on each slot.
4. Position a module over the slot so that the alignment notches on the
DIMM match the notches on the connector.
Caution: System parts are sensitive to electrostatic discharge and can be
damaged by the static charge you may carry. You should wear a
grounded wrist strap.
5.
Press firmly with your thumbs on both top ends of the module, applying
equal pressure until the module snaps into place. Lock the module in the
socket by pushing up on the ejector levers until they are in their upright
position.
1.
Single processor models will utilize DIMM pairs 1 and 3 only. The first
pair of modules is to be installed in DIMM pair 1 (blue sockets) and the
second pair in DIMM pair 3 (black sockets).
2. Dual processor models will utilize all four DIMM pairs. The first pair of
modules is to be installed in DIMM pair 1 (blue sockets), the second pair
in DIMM pair 2 (blue sockets), the third pair in DIMM pair 3 (black
sockets) and the fourth in DIMM pair 4 (black sockets).
Caution: Confirm the modules are fully and evenly seated in the slots.
Improper seating can cause electrical shorts that can damage
the memory and/or the system.
6.
Continue to install the remaining memory modules until you have filled
the bank with two identical modules. Repeat the above steps for each
bank of memory you wish to install.
7.
Reconnect the power cords and external cables, and turn on the system.
8. After you reboot, ensure the system recognizes the new memory
configuration.