Coral Industries Regal Swing Door/DPNL (1/4 Frameless) - 5FJ - Manual (Page 7)

5FJ-P 8/08
Hinge
Door Stop
8A x 3/8 "
Truss Head
Screws
K
D
A
Side
Panel
Secure sill by drilling, from outside shower, through
sill into magnetic door stop and hinge stop. Secure
using 8A x 3/8" truss head screw.
OUTSIDE OF SHOWER
Sill
9 Securing Verticals
Magnetic
Door Stop
Side
Panel
Door
Panel
10 Push / Pull Handle Kit
(E)
Handles will be mounted on glass before hanging door panel.
Push / Pull handle kit (E) comes with parts assembled in the
order they will be once installed on glass. Disassemble parts.
Place bushings in holes in glass. Trim as needed so that
bushings are flush with surface of glass. Place one plastic
washer on each connector screw and insert screws (from
inside surface of glass) through bushings in glass.
Place second plastic washer on exposed end of connector
screws on outside surface of glass. Holding exterior handle
in place on outside surface of glass, tighten connector screw
to secure handle.
On inside surface of glass, slip interior handle over connector
screws and tighten with 3/32" allen wrench.
Exterior
Handle
Plastic
Washer
Handle
Connector
Screw
Bushing
Plastic
Washer
INSIDE OF SHOWER
3/32 Allen
Wrench
Interior
Handle
Push/Pull Handle Kit E
Measure width of door glass at bottom. Trim vinyl drip
sweep (V) to door glass width minus 1/8”. Trim only from
hinge end of drip sweep. Contour cut end of drip sweep fin
to remove sharp point.
Press drip sweep onto bottom edge of door glass with fin
facing inside of shower and edge of drip sweep flush with
edge of glass on hinge side of door. (Drip sweep will be 1/8”
from edge of glass on opening side of door.)
V Vinyl Drip
Sweep Fin faces inside
of shower.
OUTSIDE OF
SHOWER
11 Vinyl Drip Sweep
(V)
Drip Sweep length =
Door Width minus 1/8”