Coral Industries Regal Swing Door/DPNL (1/4 Frameless) - 5FJ - Manual (Page 5)

5FJ-P 8/08
Measure from wall to wall over the top of both jambs and
cut header (C) to that measurement.
Position header so that long leg is toward inside of
shower. Lower into place over jambs and side panels.
This will provide stability while positioning door stops
and door.
OUTSIDE OF SHOWER
Header C
Long Leg
of Header
faces
inside of
shower
4 Header
(C)
Jamb
B
Measure
Side Panel
OUTSIDE OF SHOWER
OUTSIDE OF
SHOWER
Vinyl door seal must be removed, trimmed into two pieces,
and replaced in open channel of magnetic door stop with
metal slide (attached to magnet in magnetic catch kit (F))
in between vinyl pieces.
Remove vinyl door seal from channel. Mark center of
magnetic door stop. Trim vinyl door seal to fill open channel
of door stop from sill to 2” below center mark.
Insert metal slide (attached to magnet in magnetic catch kit)
in channel on top of vinyl. Insert remaining piece of vinyl in
channel on top of metal slide. Trim vinyl flush with door stop
at top of unit.
Choose which will be the opening side of your door. Door
is normally installed to open on side nearest to showerhead.
Slide magnetic door stop (D) into jamb or double channel
on opening side of door, making certain that vinyl door seal
(S) faces outside of shower.
Vinyl
Door
Seal S
2” Below Center
Center
Magnetic
Door Stop
Metal Slide
S Vinyl Door Seal
Cut vinyl door seal to fill
area between sill and 2”
below center mark.
D
F
Trim Vinyl Door Seal
flush with top of
Magnetic Door Stop
6 Magnetic Catch Kit
(F)
Vinyl
Door
Seal V
Magnetic
Door Stop
D
Side
Panel
Header C 5 Magnetic Door Stop
(D)
Door is normally
installed to open
nearest showerhead.
Door
Showerhead