Coral Industries Regal Swing Door/DPNL (1/4 Frameless) - 5FJ - Manual (Page 2)

5FJ-P 8/08
PARTS LIST
TOOLS NEEDED
1/8" Drill Bit
3/16" Drill Bit
(3/16" Masonry Bit
for Ceramic Tile)
Scratch Awl
Measuring Tape
Hacksaw
Phillips Screw Driver
Caulking Compound
File
Drill
Level
Masking Tape
KEY DESCRIPTION PART QTY
A SILL A855 1
B JAMB A942 2
C HEADER A101 1
D MAGNETIC DOOR STOP A993 1
S VINYL DOOR SEAL V678 1
V VINYL DRIP RAIL SWEEP V001 1
J 8A X 1 PAN HEAD SCREW H475 8
K 8A X 3/8 TRUSS HEAD SCREW H470 24
L ANCHORS H002 8
E PUSH/PULL HANDLE KIT HSAD 1
PLASTIC WASHER 4
BUSHING 2
EXTERIOR PULL HANDLE 1
INTERIOR PULL HANDLE 1
HANDLE CONNECTOR SCREW 2
F MAGNETIC CATCH KIT HKMAGCH 1
MAGNET HOLDER WITH MAGNET HMAH / HG92 1
METAL SLIDE HA75 1
HANDLE VINYL V208 1
FRAME PACKAGE
HARDWARE BAG
Before starting installation of your new enclosure, carefully read all instructions
and lay out parts to become familiar with their identity.
USE OF ANCHORS
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure
to a fiberglass unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with
an 1/8" drill bit.
Mounting this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes in
the tile, lightly chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors into
the holes making certain that ring on large end of anchor meets the surface of the tile.
CLEANING
SEALING
Seal unit by caulking along outside of enclosure where metal and bath meet, especially where sill meets threshold. If desired,
caulk inside of enclosure where jambs meet walls.
Cleaning and care of your enclosure is important to its lasting beauty. A nonabrasive liquid cleaner is recommended.
Never use scouring powder or pads.
CAUTION
Do not attempt to cut mirrors or glass used in this enclosure. Tempered glass and mirrors will shatter if cut.
Care should be taken when standing raw glass on its edge. Glass may shatter if corners are bumped or edge is rested on
a rough floor surface. Cardboard, wood blocks, or a similar surface is a safe resting surface for glass.