Coral Industries Regal Swing Door/DPNL (1/4 Frameless) - 5FJ - Manual (Page 6)

5FJ-P 8/08
Adjust alignment of door panel, magnetic door stop,
double channel, and in-line panel so that magnetic
catch aligns evenly and door closes with an even reveal
of space at top and bottom of door glass.
Once desired alignment of parts has been achieved,
working from inside of shower, drill four evenly spaced
holes through leg of jambs (1/4" from edge) into panel
and door stop. Secure using 8A x 3/8" truss head
screws (K).
Secure double channel in same manner by drilling,
from inside of shower, four evenly spaced holes 1/4"
from edge of double channel into panel and door stop.
Secure using 8A x 3/8" truss head screws.
Secure header by drilling, from inside of shower, through
header into jambs and double channel. Secure using
8A x 3/8" truss head screws.
When securing parts together, work from inside
of shower. Do not drill through to front (outside)
surface. Do not hit glass with drill bit. Glass is
seated approximately 1/2" into channel.
Jamb
INSIDE OF SHOWER
Door
Panel
Header
Side Panel
8A x 3/8"
Truss Head
Screws
K
B
C
1/4"
1/4"
1/4"
1/4"
Slide hinge door stop, which is attached to door panel,
on opposite side from magnetic door stop. For safety
purposes, door should be installed to open out from
shower.
8 Securing Verticals
7 Hinge Door Stop / Door Panel
Hinge or
Magnetic
Door Stop
INSIDE
OF SHOWER