BoonDocker EBC - Manual (Page 4)

BoonDocker Performance 2379 W. Heyrend Way Idaho Falls, ID 83402
Toll Free (US) 877-552-6127 or 208-542-4411 www.boondockers.com
Revised 10-28-11 Electronic Boost Controller install/operation instructions Page 4
adding fuel at idle. Changing the direction twice without making an adjustment will lock the calibration
and the flashing will stop.
More information on using the buttons and menus follows.
Using the EBC
There are several user menus, some having numbers or selections that are adjustable by the user. Each
value or selection is preceded by one or more scrolling labels that describe the value or selection. These
descriptive labels along with the value comprise one element. The button on the box can be used to
display the element description, make adjustments, or advance to the next element. For example, the
boost-setting element works like this:
SET
BST
8.5
These first two labels (“SET” and “BST”) each show for a fraction of a second each,
then the display stops on the value (“8.5” in this example). If the number is
showing, a quick button push will display “SET” and “BST” again, to remind you
which value is currently displayed. Since this number is adjustable, holding the
button for one second causes the “5” to flash. While it is flashing, quick presses of
the button will cause this digit to scroll zero through nine. Holding a button for one
second will advance to the next digit (“8” in this example) which will then flash.
Quick button presses adjust this value. When the third digit value is set, holding the
button for one second locks in the value and the flashing stops. The new boost
setting will not be locked in unless you pass through all three digits. While any label
such as “SET” or “BST” are showing, a quick button press will advance to the next
element. You can advance through several elements quickly by repeated presses of
the button.
Some elements have text selections, such as “YES” and “NO”, rather than numbers. Press and hold the
button one second to make the selection flash, then use quick button presses to toggle or scrool through
the choices. A one second button push locks it in.
There are three elements in normal mode: Set Boost (SET BST), Set Plus HP (SET +HP), and Altitude
(ALT). Whenever you are on boost, actual boost pressure is displayed. When off boost, the last menu
shows again.
There are six elements in user configuration mode. To get to user configuration mode, go to the altitude
screen, then press the button for five seconds until CFG is displayed. You now have access to all the
configuration elements. You can exit configuration mode so that the menu only shows the three elements
of the normal user menu.