CDI Torque SURETEST Torque Calibration System - Manual (Page 65)

MANUAL LOADER CHAPTER 6
6-64
4-in-1 Transducer (Accessory)
The 4-in-1 transducer is mounted to the loader using the standoff fixture and bracket assembly as
shown in Figure 6-5.
Figure 6-5: 4-in-1 Transducer on 2000-600-02 Manual Loader
A- Quick Release Pins
Four quick release pins must be installed. The first two secure the standoff fixture to the loader
and the second two lock the adaptor to the transducer bracket.
B- Loader Standoff (under bracket)
The standoff and bracket must be installed into the loader by lining up the holes of the standoff to
the holes of the loader.
C & D- Bracket Knobs
Two knobs on the bracket are used to align the selected transducer over the loader drive. Tighten
the left knob (D) first, then the top knob (C). The wrench or driver to be tested is then coupled to
the selected transducer using an internal-internal adaptor.