CDI Torque SURETEST Torque Calibration System - Manual (Page 28)

SETUP AND PROGRAMMING CHAPTER 3
3-27
4-in-1 Transducer Installation
When a 4-in-1 transducer is installed, the following is displayed:
All four transducers are scanned as indicated by their associated red LED indicators. To select
one of the transducers, apply at least 5% of its full range torque. To return to the scan mode, press
ENTER.
Single Transducer Installation:
When a single transducer is installed, the following is displayed:
The user can enter Setup mode then proceed to make Torque measurements.