Catler RC 4010 - Manual (Page 7)

5
CATLER RECOMMENDS SAFETY FIRST
FULLY UNWIND THE CORD BEFORE USE.
DO NOT OPERATE THE APPLIANCE ON AN INCLINED SURFACE.
DO NOT MOVE THE APPLIANCE WHILE IT IS SWITCHED ON.
THE POWER PLUG WHEN PLUGGED MUST REMAIN ACCESSIBLE FOR EASY
REMOVING.
ENSURE THE APPLIANCE IS FULLY COOLED BEFORE CLEANING AND STORING.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS FOR ALL
ELECTRICAL APPLIANCES
•
Fully unwind the power cord before use.
• Connect only to 230V or 240V power
outlet.
• Do not let the power cord hang over
the edge of a bench or table, touch hot
surfaces or become knotted.
• To protect against electric shock, do not
immerse the power cord, power plug or
appliance in water or any other liquid or
allow moisture to come in contact with
the part, unless it is recommended in the
cleaning instructions.
• The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
• It is recommended to regularly inspect
the appliance. To avoid a hazard, do not
use the appliance if power cord, power
plug or appliance becomes damaged
in any way. Return the entire appliance
to the nearest authorized Catler service
centre for examination and/or repair.
• Any maintenance other than cleaning
should be performed at an authorised
Catler Service Centre.
• This appliance is for household use only.
Do not use this appliance for anything
other than its intended use. Do not use
in moving vehicles or boats. Do not use
outdoors. Misuse may cause injury.
• The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
when using electrical appliances. It is
advisable that a safety switch with a rated
residual operating current not exceeding
30mA be installed in the electrical
circuit supplying the appliance. See your
electrician for professional advice.
• Always turn the appliance to the OFF
position, switch off at the power outlet
and unplug at the power outlet when the
appliance is not in use.
• Before cleaning, always turn the
appliance to the OFF position, switch off
at the power outlet, unplug at the power
outlet and remove the power cord, if
detachable, from the appliance and allow
all parts to cool.
• Do not place this appliance on or near
a heat source, such as hot plate, oven or
heaters.
• Position the appliance at a minimum
distance of 20cm away from walls,
curtains and other heat or steam
sensitive materials and provide adequate
space above and on all sides for air
circulation.